ASET PRODUCTION TRADE TESTS

Each Production Trade Test consists of an online knowledge test and practical task based assessment and takes around 2 hours to complete. On completion of the tests, both employers and technicians will know exactly where they are with respect to their occupational competency and whether additional coaching or on-the-job training is required.

Booking

For further details contact our Customer Service Team on 0300 330 5559 or email us at asetbookings@aset.co.uk

The Tests

All of the below Production Trade Tests are exclusively carried out on ASET’s market leading live and fully integrated ABCOL Oil & Gas Production Training Platform, allowing the delegates a live and hands on experience of oil and gas production operations.

Changeover of Pressure Safety Valves (PSV’s)

Demonstrate how to change over the PSV’s on the separator (V1400) using the correct procedure. (AC3 and AC1 to be online)

Basket Filter changeover

Change over the basket filters on AC1 system whilst they are online, checks to include identifying what the differential pressure in on the online filter prior to changing them over. (AC3 and AC1 to be online)

Deluge Pump changeover

Change over the status of the deluge pumps from parallel mode to series mode using the correct procedure, identifying the main change with flow and pressure. (AC3 and AC4 to be online)

Understanding P&ID’s

Line walk AC1 system with marked up P&ID’s and checklist

Familiarisation of Chemical Injection Skid

Set up the chemical injection skid at a rate of 40mls per minute. (AC3 and AC1 to be online)

Activate Fire & Gas System

Set up the deluge skid as per the procedure, then activate a deluge release by bringing in two heat / flame detectors. (AC4 and AC1 to be online)

Metering Skid start up

Demonstrate how to start up the metering skid using the correct procedure. (AC3 to be online)

Air Compression start up

Pre start checks, start up and shut down of the air compressor using the correct procedure. (AC3 to be online)

Maintain steady state conditions on a live plant

Maintain steady state conditions within AC1 system by balancing both T-1000 and V-1400 vessels. (AC3 and AC1 to be online)

Identification of Faults on a live plant

Fault finding exercise on AC1 system. (AC3 and AC1 to be online)

Identification of different types of Valves

Identification of different of different types of valves within the ABCOL Oil & Gas Production Training Platform.

Risk Assessment on a live plant

Risk assessment exercise for a task on the ABCOL Oil & Gas Production Training Platform. (AC3 and AC1 to be online)

Understanding P&ID’s on an Air System

Identify the flow path on the air system within the ABCOL Oil & Gas Production Training Platform and highlight the major components within the system. (AC3 and AC1 to be online)

Understanding Cause & Effect

Set the pressure on the separator (V1400) to 4 bar then increase in 0.5 bar increments until the separator trips. Identify what the actions are using a dedicated cause and effect sheet. (AC3 and AC1 to be online)

Understanding and following Operational Performance Guidelines (OPG’s) for start up of a live plant

Reset all ESDS for AC3 and AC1 in preparation for startup using correct OPG’s.

Understanding and following Operational Performance Guidelines (OPG’s) for resetting a Pump

Set FCV 1003 on AC1 to 25% in manual in preparation for startup, apply an inhibit on F11200 to allow the pump to be reset in preparation for startup. (AC3 and AC1 to be online)

Heat Exchangers

Bring the heat exchangers online to begin the transfer of heat between two different process streams

© Aset 2024. All rights reserved.
Designed and Developed by Art Department